- Dec 27, 2013
-
-
Rafał Miłecki authored
Signed-off-by:
Rafał Miłecki <zajec5@gmail.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
Weilong Chen authored
Fix checkpatch error with space. Signed-off-by:
Weilong Chen <chenweilong@huawei.com> Signed-off-by:
-
Weilong Chen authored
Signed-off-by:
-
Ben Hutchings authored
All other net drivers with PTP support enable it unconditionally. Make tile_net consistent with this. Signed-off-by:
Ben Hutchings <bhutchings@solarflare.com> Acked-by:
Chris Metcalf <cmetcalf@tilera.com> Signed-off-by:
-
- Dec 26, 2013
-
-
David S. Miller authored
drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c: In function 'bnx2x_drv_info_ether_stat': drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c:3302:46: error: dereferencing pointer to incomplete type make[6]: *** [drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.o] Error 1 Reported-by:
Eric Dumazet <eric.dumazet@gmail.com> Signed-off-by:
-
Michal Schmidt authored
The recent conversion to skb_set_hash() was incorrect. 'skb' is uninitialized at this point. Fixes: 0b680703 ('net: vmxnet3 calls skb_set_hash') Signed-off-by:
Michal Schmidt <mschmidt@redhat.com> Acked-by:
Tom Herbert <therbert@google.com> Signed-off-by:
-
Yang Yingliang authored
When we set burst to 1514 with low rate in userspace, the kernel get a value of burst that less than 1514, which doesn't work. Because it may make some loss when transform burst to buffer in userspace. This makes burst lose some bytes, when the kernel transform the buffer back to burst. This patch adds two new attributes to support sending burst/mtu to kernel directly to avoid the loss. Signed-off-by:
Yang Yingliang <yangyingliang@huawei.com> Acked-by:
Eric Dumazet <edumazet@google.com> Signed-off-by:
-
wangweidong authored
Signed-off-by:
Wang Weidong <wangweidong1@huawei.com> Signed-off-by:
-
wangweidong authored
fix checkpatch errors below: ERROR: that open brace { should be on the previous line ERROR: open brace '{' following function declarations go on the next line ERROR: trailing statements should be on next line Signed-off-by: -
wangweidong authored
fix checkpatch errors below: ERROR: switch and case should be at the same inden ERROR: code indent should use tabs where possible Acked-by:
Neil Horman <nhorman@tuxdriver.com> Signed-off-by:
-
wangweidong authored
fix checkpatch errors below: ERROR: "(foo*)" should be "(foo *)" ERROR: "foo * bar" should be "foo *bar" ERROR: "foo* bar" should be "foo *bar" Signed-off-by:
-
wangweidong authored
fix checkpatch errors while the space is required or prohibited to the "=,()++..." Acked-by:
-
Weilong Chen authored
Fix some checkpatch errors for tcp_ipv6.c Signed-off-by:
-
Weilong Chen authored
This cleanup the comments in tcp_yeah.c. 1.The old link is dead,use a new one to instead. 2.'lin' add nothing useful,remove it. 3.do not use C99 // comments. Signed-off-by:
-
Weilong Chen authored
Signed-off-by:
-
Weilong Chen authored
Signed-off-by:
-
Weilong Chen authored
Signed-off-by:
-
Weilong Chen authored
Signed-off-by:
-
Weilong Chen authored
Signed-off-by:
-
Weilong Chen authored
Fix checkpatch errors like: ERROR: spaces required around that XXX Signed-off-by:
-
David S. Miller authored
Yuval Mintz says: ==================== bnx2x: new features patch series This patch series adds/fixes several new features in the bnx2x driver - it adds support for loading the bnx2x over an UNDI running on a Multi-function device, adds missing bits for PCIe AER support and enables VFs to properly configure multicast filters (In addition, it also contains some small improvements in driver behaviour). Please consider applying these patches to `net-next'. Changes from previous versions ------------------------------ v2: - Fixed comment typo in patch 4 (propogate --> propagate) ==================== Signed-off-by: -
Yuval Mintz authored
This patch adds the necessary support for configuring (and removing) multicast filters to VFs. Signed-off-by:
Yuval Mintz <yuvalmin@broadcom.com> Signed-off-by:
Ariel Elior <ariele@broadcom.com> Signed-off-by:
-
Yuval Mintz authored
Signed-off-by:
-
Yuval Mintz authored
It's possible for VMs with older versions of bnx2x to run over a hypervisor with latest driver. If a VF in such a VM does not support RSS configuration, the PF driver in the hypervisor will print an error message to system logs. This changes the error message into a debug message, as this is very likely a false alarm for an older VF (i.e., VF manages to work properly; PF simply cannot configure the additional queues for it). Signed-off-by:
-
Yuval Mintz authored
There's a known issue that using `ethtool -e' flips the endianity of the written data, i.e., using `ethtool -E' to dump eeprom image and than using `ethtool -e' to re-write that same image will result in an image where the data has the opposite endianity. Sadly, this cannot be fixed as there are already various tools deployed based on the endianity of the eeprom read/write. Instead, a comment is added to the code to help explain why this is un-fixable. Signed-off-by:
-
Yuval Mintz authored
This function adds several OS calls required to fully enable PCIe AER support - pci_enable_pcie_error_reporting() and pci_cleanup_aer_uncorrect_error_status(). Signed-off-by:
-
Yuval Mintz authored
This adds the ability for bnx2x to load after UNDI is used in the preboot environment on a multi-function interface which is not the first interface of a given device. Notice a side-effect is that the order by which the functions are probed and thus interfaces appear might change, as this patch utilizes the EPROBE_DEFER return value (and mechanism). Signed-off-by:
-
David S. Miller authored
Ding Tianhong says: ==================== slight optimization of addr compare for some modules Joe Perches add ether_addr_equal_unaligned to test if possibly unaligned to u16 Ethernet addresses are equal. If CONFIG_HAVE_EFFICIENT_UNALIGNED_ACCESS is set, this uses the slightly faster generic routine ether_addr_equal, otherwise this uses memcmp. So I use the recently added and possibly more efficient ether_addr_equal_unaligned to instead of memcmp for slight optimization. v2: Because a lot of places are already using 16b aligned MAC address for both operands, so use the ether_addr_equal to instead of ether_addr_equal_unaligned.Thanks for Joe, Alex and Antonio's opinions. Also remove the patch for bridge. v3: According Joe's suggestion, the patch (net: slight optimization of addr compare for some modules) should be broken into several patches, and it will be good to review for maintainers. So I will send rest of the patches for first step, and next step, I will seperate the netdev patch and send them by another patchset for net-next. also fix some changelog. v3.5 Change some style for patch 8 and patch 13. Thanks for Sergei's suggestion. ==================== Signed-off-by: -
dingtianhong authored
Use possibly more efficient ether_addr_equal or ether_addr_equal_unaligned instead of memcmp. Cc: John W. Linville <linville@tuxdriver.com> Cc: linux-wireless@vger.kernel.org Cc: netdev@vger.kernel.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
Ding Tianhong <dingtianhong@huawei.com> Signed-off-by:
-
dingtianhong authored
Use possibly more efficient ether_addr_equal_unaligned instead of memcmp. Cc: Larry Finger <Larry.Finger@lwfinger.net> Cc: Chaoming Li <chaoming_li@realsil.com.cn> Cc: John W. Linville <linville@tuxdriver.com> Cc: linux-wireless@vger.kernel.org Cc: netdev@vger.kernel.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
-
dingtianhong authored
Use possibly more efficient ether_addr_equal instead of memcmp. Cc: Bing Zhao <bzhao@marvell.com> Cc: John W. Linville <linville@tuxdriver.com> Cc: linux-wireless@vger.kernel.org Cc: netdev@vger.kernel.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
-
dingtianhong authored
Use possibly more efficient ether_addr_equal instead of memcmp. Cc: Stanislav Yakovlev <stas.yakovlev@gmail.com> Cc: John W. Linville <linville@tuxdriver.com> Cc: linux-wireless@vger.kernel.org Cc: netdev@vger.kernel.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
-
dingtianhong authored
Use possibly more efficient ether_addr_equal instead of memcmp. Cc: Solomon Peachy <pizza@shaftnet.org> Cc: John W. Linville <linville@tuxdriver.com> Cc: linux-wireless@vger.kernel.org Cc: netdev@vger.kernel.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
-
dingtianhong authored
Use possibly more efficient ether_addr_equal instead of memcmp. Cc: Jouni Malinen <j@w1.fi> Cc: John W. Linville <linville@tuxdriver.com> Cc: linux-wireless@vger.kernel.org Cc: netdev@vger.kernel.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
-
dingtianhong authored
Use possibly more efficient ether_addr_equal instead of memcmp. Cc: Mauro Carvalho Chehab <m.chehab@samsung.com> Cc: linux-media@vger.kernel.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
-
dingtianhong authored
Use possibly more efficient ether_addr_equal instead of memcmp. Cc: Karsten Keil <isdn@linux-pingi.de> Cc: netdev@vger.kernel.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
-
dingtianhong authored
Use possibly more efficient ether_addr_equal instead of memcmp. Cc: Chas Williams <chas@cmf.nrl.navy.mil> Cc: linux-atm-general@lists.sourceforge.net Cc: netdev@vger.kernel.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
-
dingtianhong authored
Use the possibly more efficient ether_addr_equal to instead of memcmp. Cc: Johannes Berg <johannes@sipsolutions.net> Cc: John W. Linville <linville@tuxdriver.com> Cc: David Miller <davem@davemloft.net> Cc: linux-wireless@vger.kernel.org Cc: netdev@vger.kernel.org Signed-off-by:
-
dingtianhong authored
Use the possibly more efficient ether_addr_equal to instead of memcmp. Cc: Roland Dreier <roland@kernel.org> Cc: Sean Hefty <sean.hefty@intel.com> Cc: Hal Rosenstock <hal.rosenstock@gmail.com> Cc: Faisal Latif <faisal.latif@intel.com> Cc: linux-rdma@vger.kernel.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
-
dingtianhong authored
Use possibly more efficient ether_addr_equal instead of memcmp. Cc: Rupesh Gujare <rupesh.gujare@atmel.com> Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org> Cc: devel@driverdev.osuosl.org Cc: linux-kernel@vger.kernel.org Signed-off-by:
Tan Xiaojun <tanxiaojun@huawei.com> Signed-off-by:
-
